Search results

Yes the skid plate for the trailhunter still works.

The 822's are perfect. No difference in the ride at all.

Did you check the fuse? The 3 aux fuses are under the hood on the drivers side.

I didn't notlice a change in ride quality with the new springs up front. The spacers don't affect anything in the rear cause they don't preload.

It's not set up as a snorkel. It's made to reduce the dust going into the intake by pulling air higher up. Still questionable. I believe it can be sealed so you can go snorkeling 🤿

It's part of the Trailhunter package.

C4 rock sliders arrived today. Prepping for paint... degreased the bare steel. Will apply POR15 base coat tomorrow and will top coat. Base and top coat just finished

I didn't have any trouble with the passenger side. The speaker was slightly in the way so I just bent it up a bit so I could get the screw driver in there. The whole job took about an hour.

Rigid ARB bumper lights with SPV wire harness installed. Very simple install made easy by the SPV wire harness.

Glad I found this thread. Thank you all. I ordered from SPV and will receive it tomorrow. Look forward to getting it together after the kitchen shows.

I did 35% up front only. I think the rears are about 20% privacy glass. Not sure about that. I have 20% up front on my previous trucks and it was too dark at night.

You don't need to add the springs but keep in mind, with the bumper and winch you are adding about 150lbs to the front. In my case, it sagged about 1/2". I brought it back up with the springs and lifted it about 1 1/2" beyond stock.

$4500 for the PPF

😁

Today I added dobinson springs to the front to compensate the newly added front bumper/ winch weight. It also raised the truck by about 1 1/2". I also order the the rears but they are on backorder so in the mean time, I installed 1" peak spacers. Changing the suspension on this Tacoma might...

I ended up going with the Rago center mount bumper, warn winch and Stinger relay hooked up to Aux 2 switch. I received the Rago bumper Friday. They gave me a deep discount on it try out as they never fit them on a Trailhunter. Beautifullly made and very robust. Fitment once I made some...

I did some cosmetic changes to the exterior including the PPF and tint Added arb traction boards and the hi lift. Made some brackets to mount the boards to the hi lift. The hi lift is mounted to the bed rail t slot

I bought the Tailhunter in underground color January 2025. I started my driving life in a Toyota 1991 pickup. In 2010 I got a 2G Tacoma DCLB modded for wheeling and went to another 2g DCLB and switched all the mods over to that truck. Since then, I've been driving around larger amercin 2500...

I received the Rago bumper Friday. Beautifullly made and very robust. Fitment once I made some modifications to the bumper for the TH is perfect. I installed it yesterday. Rago only accounts for the standard model fogs. The rigid fogs project out further (about 3/8")so I had to modify the...

Agreed. Although I blame those cuts(as you mentioned) on the installer. They must perform under the the "never measure, cut once" philosophy. They should have measured, then rough cut long and fine sand to perfection.