Search results

Looks like they didn't touch the camber. I would get that fixed. My tires got smoked from the bad camber from the factory. I even had it realigned after putting new tires on and the alignment shop said it was in spec with the crazy camber. I just put on new tires again (went with 35's) and had...

Today I ended up going with falken wildpeak at4w 35x11.5 tires. Just needed to remove the crash plates in the front wheel wells. Other than that, no rubbing on anything. Perfect fit! The wildpeaks ride a little stiffer than the toyos even be load rating c. Acceptable and very minor difference in...

They really aren't up to the task. The passenger side front end of the slider kissed the rocker panel and made a small knick in it after i came down down on a rock. It dented the slider and bent it up a bit. After that, I knew they had to go. I still have them in my shop and will take a Pic of it.

Looking great! I may go with the hitch slider like you have. I hit that hitch a few times and may want protection. I ended up ditching the sliders on my TH and going with the C4 sliders. The stock sliders weren't up to the task and ended up getting dented/bent up after wheeling adventure. Just...

Yes the skid plate for the trailhunter still works.

The 822's are perfect. No difference in the ride at all.

Did you check the fuse? The 3 aux fuses are under the hood on the drivers side.

I didn't notlice a change in ride quality with the new springs up front. The spacers don't affect anything in the rear cause they don't preload.

It's not set up as a snorkel. It's made to reduce the dust going into the intake by pulling air higher up. Still questionable. I believe it can be sealed so you can go snorkeling ?

It's part of the Trailhunter package.

C4 rock sliders arrived today. Prepping for paint... degreased the bare steel. Will apply POR15 base coat tomorrow and will top coat. Base and top coat just finished

I didn't have any trouble with the passenger side. The speaker was slightly in the way so I just bent it up a bit so I could get the screw driver in there. The whole job took about an hour.

Rigid ARB bumper lights with SPV wire harness installed. Very simple install made easy by the SPV wire harness.

Glad I found this thread. Thank you all. I ordered from SPV and will receive it tomorrow. Look forward to getting it together after the kitchen shows.

I did 35% up front only. I think the rears are about 20% privacy glass. Not sure about that. I have 20% up front on my previous trucks and it was too dark at night.

You don't need to add the springs but keep in mind, with the bumper and winch you are adding about 150lbs to the front. In my case, it sagged about 1/2". I brought it back up with the springs and lifted it about 1 1/2" beyond stock.

$4500 for the PPF

?

Today I added dobinson springs to the front to compensate the newly added front bumper/ winch weight. It also raised the truck by about 1 1/2". I also order the the rears but they are on backorder so in the mean time, I installed 1" peak spacers. Changing the suspension on this Tacoma might...

I ended up going with the Rago center mount bumper, warn winch and Stinger relay hooked up to Aux 2 switch. I received the Rago bumper Friday. They gave me a deep discount on it try out as they never fit them on a Trailhunter. Beautifullly made and very robust. Fitment once I made some...