Search results

So I am using the Rough Country e -boards. Install went fine including the oem switch mod. Followed the pinouts provided by another member that was posted to a different forum (the link I provided earlier). A good resource. Not much drama but took much longer than I expected. Also, my first...

I went with a custom 'milk crate' - the pedestal is made from a 2x4, sits on the tailgate, the runners sit in the grooves in the tailgate to help hold it in place, and the top is flush with the two 2x6s in the notches. For added security so I don't worry about if flying off the back of the...

I am doing the install myself tomorrow with the oem switch. A couple of resources I found helpful: - For the pigtail to connect the switch to the RC harness, I sourced from (it has both mail and female plugs but only need the one that works fine). Was unable to source from a salvage yard and...

I am looking to do the same running board install with the factory switch. Were you able to get the pinout sorted for the on off functions and if so are you able to share? Does the switch illuminate like the others in the dash? How did you connect the wires to the switch? Thank you.

So I installed the OEM divider in my TRD Offroad today with OEM bed mat and OEM trifold cover. The answer is yes it fits with about 1/8 in gap between the bottom of the divider and the mat. (at least in the middle of the bed where I placed mine). Similar to what others have said I needed to...

OEM cover + bed mat + divider? So I have read through this thread 3 times before posting my question. Just installed the OEM cover with OEM Tacoma bed mat. Very happy so far and made my decision after reading this thread. Looking to purchase and install the OEM bed divider next. From this...