Search results

I would think that you'll have to replace the liner that he cut. I'm assuming that you didn't get the rustproofing done at the dealer. Was that a shop that does rustproofing? He should make it right if he has any integrity. Threaten to give his shop negative reviews on Google. Document...

Here's mine. There are only 2 with the Phillips center. They are in the front lower position in the driver and passenger sides. All the others have blank centers. I don't think it really matters as long as the screws have the same thread and hex head size (other than aesthetics) .

I'm in Calgary, Alberta. I'm actually using the Cochrane, Alberta dealership, since that's where I purchased the vehicle. I'm also getting an oil change and am getting the L99 blind spot monitor reprogramming done while I'm there.

I got the recall notice in the mail last week and have an appointment to get it done next Wednesday. The service advisor at the dealership just got notified that they had the parts and could do it.

I used BMW structural foam (2 part epoxy) to reinforce the subframe on an E46 BMW M3. It filled the cavity between the subfloor in the trunk and the rear subframe. This was the prevent the subfloor from cracking from the constant flexing. This was a common problem on the E46 platform, especially...

I have a 2024 Tacoma TRD Offroad Premium. I live in Calgary, Alberta, Canada. We have a couple of high speed roads that are bad for kicking up winter salt and gravel and busting windshields. Front glass insurance coverage is always extra. I opted for it and sure enough, I got a large crack...

That doesn't have an air dam and hood gasket to block off engine heat. That is not a cold air intake. It also does not have a fitting for a MAF and I have no idea why there is a hose connection on the pipe. I'd avoid this if I were you.