Search results

Those of you with the cover, is the center part of your bed cap significantly lower than the end of the caps, as shown in my pic below?

Surprisingly it was really easy. I barely had to use any force to get mine off. It was 95 degrees in the sun, so that may have helped. Start near the tail light and slowly work your way to the front pulling gently from both sides of the cap until you hear the clip disengage. DO NOT bend the cap...

They’ll fit. Here’s how is set up my shims.

Here’s a pic of how I placed my spacers for anyone about to do this.

For those of you with the SE or HD, how tight did you tighten the clamps? I torqued to the recommend 4-5 ft/lbs and they were still loose, so I kept tightening until I couldn’t move them freely but now I have metal shavings from the clamps and the bolts almost look like they bend at an angle. I...

I like those! But my luck, those things would fly out on the highway.

Really? Could you post a pic for reference?

Ah yes, there it is. So it’s a 4th gen issue with these. Not that it’s a problem, but two different people commented on how much the trim lifted up when they saw the truck in person.

I installed some Wearhertech rain guards on my ‘25. I love the functionality and the look but the trim piece sticks out significantly. This didn’t happen with the 3rd gen and I don’t see other brand trucks with this issue. My concern is how much it stretches out the window trim and the...

Do you remove the bed caps the same way as the caps without the lights? And were you able to fit all the shims with the wiring under there? I just ordered the SE for my short bed Bronze Oxide.

I just ordered the SE. do you remove the bed caps the same way as the ones without the lights? And do the spacers at the bottom fit with all that wiring? Thanks

Are you guys using hub centric rings with these? And will the center cap fit with the rings? Thanks