Search results

Completely overlooked the "TRD Pro" part...apologies.

Take the actual turn signal bulb out of the light. The remove the bulb, plug this light in and plug the bulb into this lights connector. (Assuming that is what you were asking)

For the Aspire lights...there is a fuse splitter on one end. You just pull the fuse (the instructions indicate which one), put the splitter in and put the fuse back in on top. I did cut a hole and feed the wire through the plastic box that the fuses are in (like in the youtube video...

I did not, I just jammed my arms down behind the lights and worked them free...scratched the sh*t out of myself. Someone up thread suggested using a Hole saw bit for your drill, which I am upset I didn't think of. I wasnt keeping the plastic pieces, so I should have just cut through them.

All together looks dope. I am looking at the full Tacoma system from Tmat, but I also found a pre-owned set that was for a full size F150. How many tiles do you have going front to back/side to side? From pics, maybe three 12x12 and three singles on each side? I am wondering if I can...

I did not take the bumper off, just jammed my arms in behind the light housing and tried to disengage the clips. Scratched the s*it out of myself, but got it done. Someone mentioned using a drill/dremel to cut a hole in the piece, which would have been much easier

Thank you for the breakdown. I can see where the limitations are and how the other components would be affected (control arm, bump stop etc). Not wanting to be cheap about it and I have a low risk tolerance for really harming the truck. Is an adjustable strut (Rough Country M1 ) able to be...

Yes, this is perfect. Thank you very much. The lift spacers haven't damaged your truck at all? Everything was ok during the time you had them in?

I will take all the heat you want to throw, but if you could wrap it around some constructive advice, that'd be great. The Facts: -I have a stock 2025 TRD Sport long bed. -I am a 46 yr old Accountant in NJ and this is my daily driver/kid hauler/random home depot runner/friend mover/Football...

No, I didn't have to remove bumper or grill. To get to the tabs that secure the factory plastic trim, I did have to jam my arms in behind the light housing and they got scratched up pretty good. So removing the bumper would make that easier, but I got it done without. I couldnt find...

They do stay on while the truck is on. They aren't projected, so at night they make it brighter in the immediate area in front and to the sides. Maybe 10-15feet. Like a brighter glow. I can't imagine they are affecting oncoming drivers and definitely aren't high enough or directional enough...

I just finished installing the Aspire V2 fang lights on my Tacoma. Whole install took about 45 min, but 30 of that was getting the factory plastic pieces off and zip tying the wires out of the way. Legitimately plug and play. Once the Fang light is in the bumper, you untwist the yellow turn...

Late to the party.....but the Toyota anti theft suite is virtually worthless. From the digital key /signal to Toyota Connected services vehicle tracking. I bought a new Land Cruiser in February and had it stolen in Toronto, Easter weekend. I think they copied the key signal and about a mile...

Just picked up a '25 TRD Sport in NJ....I am a middle aged accountant, so true over landing mods are not in my future. I am more trailer hitch Blackstone griddles and built-in chuck boxes for tailgates. I did see a vinyl that i love and can not find it. If you have seen it sold somewhere...