Can I get some pointers for the Pro Grille & Lightbar ?

[ScottyMcfly]

Might be too tall. But this one is $25. Idk man, you might be on yo something !

https://www.mishimoto.com/borne-off...gmd0PyOMpdHzD5cJO8044mm9bQobeiHhoCmOsQAvD_BwE

Ohhhh that one looks better

Sponsored

 

[G-Oil Guy]

A little bit more information on that fuse box. It's a Blue Sea 5025. I love Blue Sea products, but dang they are spendy. This is one of those things where you get what you pay for. I used the same fuse box when I wired up the solar in the canopy camper.

I would love more info on this entire set up. Where is it mounted? Where did you get the tray etc etc.

I’m not completely opposed to putting a block on the fuse panel lid but if I could I’d prefer to put it somewhere else where movement would be minimal.

 

[G-Oil Guy]

I just installed mine last week on my TRD off-road. Mine didn’t come with the pre-wiring, so I ran it to the battery and then through a boot in the firewall. I went with the heretic light bar as, from my research, it was the one that fit the best (and I now can confirm that). Super easy install. Maybe it took me about 1hr to 1 and a half.

Someone else asked you but I figured I’d echo it: how/what did you tap into to get the backlight on your switch to light up?

 

[Pappy]

I would love more info on this entire set up. Where is it mounted? Where did you get the tray etc etc.

I’m not completely opposed to putting a block on the fuse panel lid but if I could I’d prefer to put it somewhere else where movement would be minimal.

This set-up is mounted in my canopy camper. It's a stand alone electrical system powered off 380W solar and 200Ah batteries.

I do have another fuse block under the hood next to the air box for various electrical stuff. It's mounted with 2-side tape on the plastic skirt, passenger side.

 

[G-Oil Guy]

This set-up is mounted in my canopy camper. It's a stand alone electrical system powered off 380W solar and 200Ah batteries.

I do have another fuse block under the hood next to the air box for various electrical stuff. It's mounted with 2-side tape on the plastic skirt, passenger side.

Thank you!

 

[tacochoco]

Someone else asked you but I figured I’d echo it: how/what did you tap into to get the backlight on your switch to light up?

Sorry for the late reply, I did not tap for that my button does not backlight. Only when it’s on.

 

[G-Oil Guy]

Sorry for the late reply, I did not tap for that my button does not backlight. Only when it’s on.

No worries! Thanks for replying.

 

[braaadyyota]

There's got to be someone with a 3D printer that could make something cool.
The light bar cover is not a bad idea with some brackets !

I've got a 3d printer and have been dabbling with designing things. Such as this 5lb propane tank mount bracket that attaches to the bed rail. I'm not sure how to nicely secure that cover in the grille but I'm sure it's possible.

 

[PNWkip]

I've got a 3d printer and have been dabbling with designing things. Such as this 5lb propane tank mount bracket that attaches to the bed rail. I'm not sure how to nicely secure that cover in the grille but I'm sure it's possible.

Would be awesome man.
I'd pay ya for some brackets ! I bet others would too

Sponsored