- Thread starter
- #1
Here is a PPF template i used for the door cups.
They are about 4.25" on the short side so i used a 6" roll.
They're normally hard to see but i chose the light for this pic so you can see the lines.
Ideally this one would be 1/16" lower.
Door cups are kinda a pain. If you're an amateur like me watch some videos and expect to sacrifice a piece for practice.
I used hybrid Tac/Slip solution - only on the ppf, not applied to the door. But it seems everyone has their preferred method.
They are about 4.25" on the short side so i used a 6" roll.
They're normally hard to see but i chose the light for this pic so you can see the lines.
Ideally this one would be 1/16" lower.
Door cups are kinda a pain. If you're an amateur like me watch some videos and expect to sacrifice a piece for practice.
I used hybrid Tac/Slip solution - only on the ppf, not applied to the door. But it seems everyone has their preferred method.
Sponsored
Last edited:
