Recent content by greenno

Yeah I crawled under there today and there re a few places to mount the unit. It’s wireless the one I’m getting and just want it for airing up the bags when I tow. Also have a morflate compressor that I use when airing up/down my tires. I plumbed the lines underneath with a quick disconnect at...

Anybody found a good spot to mount an Airlift Wireless Compressor underneath the body. I had that setup on my 2019 ford f350 crew cab long bed before I sold it and there was a ton of room under there to mount it. i will crawl under there later today to cope out just wondering if anybody has...

Too bad they don’t make a replacement pillar with handle without the faux speaker grill for those of us that don’t have the JBL option on our trucks. Look kinda odd having a grill on drivers side only.

Just swapped out the stock wheels on my bronze oxide 2026 off-road and went with some method 305’s 17x8.5 +25 offset in black. Couldn’t be happier. Got a white F350 with bronze 305's too and thought about that color but decided to keep it all bronze/black for the most part.

Just upgraded mine recently with something simular. Anybody looking for a stock off road grill?

That Vent fitting has a rubber o-ring on the inside and the outside as well as a cup washer and then gets tightened down with the nut. Supposedly the o-rings are compatable with being used for fuel.

Good idea I thought about JBweld too.

Well I got the fitting I ordered and installed it into the "fuel cell" aka gas cans, fuel jugs, gas storage container. So I transferred the fuel that was in the "cell" to my truck and then drilled a small hole and installed the fitting, pretty simple. The fitting came with a cap but since I want...

Here is a quick pic of the 30L fuel cell after I removed it from my truck. Because I will be mounting the tank horizontally I can’t use the vent on the bottom under the fill area. So I am going to drill and mount a fitting along the top. As I am not planning to remove the tank and will use a...

Got an issue I would like some input on. Just purchased a 2026 Tacoma and of course it came with the standard 18g fuel tank. No larger tank available as off now. So.. I decided to get some molle panel and mount it to the front section of the rear bed area. I then purchased a plastic 30L fuel...

I picked up a front bed section of Molly panel complete with hardware for less than $100 off e Bay. Also found a 30L fuel cell and lockable mounting brackets for I think it was $130 again off e bay. Going to horizontally mount he tank against the front wall having the fill cap right next to...

Got a bike rack on the rear so that won’t work for me. I will figure something out this week and post up.

F that noise. I’m not a patient man. I looked at the Rough Country Molle panels to mount inside the rear bed and fasten up a 3g plastic can to that for like 3 bills or more. AND they are not sized for the “longbed ” version only the 5’ bed. I’m sure it would work but, being inpatient, I will...

Does anyone make a replacement fuel tank for the gen 4 Tacoma? With just 18g and only getting about 18mpg I have almost ran out of gas 2x. My previous truck (F350) had a 48g tank underneath. I cried when I filled it up but had considerable range to not be filling up every week. I know they...

What I mean is the tire is wider and maybe doesn't have as tall as look as it did with the narrower rims. Im hoping after getting the lift to space the tire away from the body it will look more proportional, for me anyway. Going from the +55 on the 7.5" wheels to the +25 on the 8.5's sticks me...