Recent content by Jeff11

Anyone with front camera who has swapped to a TRD Pro Grille from a Offroad or Sport, do you still have your original front camera bracket, and if so, would you be willing to part with it. I'll buy and pay shipping!

I just saw these. They look nice. Uses one bolt and then double sided tape. Are you using them?

Good point! Yeah wouldn't want the hood banging into the lights!

Anyone know of any ditch light brackets that mount to the A pillar bolt under the plastic trim rather than tk the underside of the hood/hinges? M&R manes a set like this. I will link it so you can see what I'm talking about. Just wondering if anyone knows of any others that mount like this...

PT989-35240-AC PT989-35240-AB PT989-35240-AA those are your part numbers for each of the three step pads.

I kept the parts list from the bumper kit. It has listed all the part numbers, including the part numbers for the step pads.

I wouldn't even bother with the dealer. The angles are essentially the same on the new bumper. Scuff the old paint down, shoot some matte black on the old sensors, and reuse them. They design it to not recognize new sensors as a way to be able to charge an extra $600 dollars for the install...

Just scuff and shoot the old sensors with a few light coats matte black paint to match the bumper. They will work perfectly. I did that after the con-artist dealer tried the same game with me.

Looking for the OEM bracket that comes to install the front camera on the TRD OR or sport front grilles. Looks like to get it from Toyota, you gotta buy the camera with it. Anyone swap to a TRD pro grill and able to part with their original camera bracket? Ill pay shipping, obv. Ty!!

Do you have any pictures of how they bolt up? Was there any issue given there is a bit of a lip from where the flare ends in the wheel well and where you install that middle bolt?

Looking to get some new flaps. I don't like the factory molded ones. They scratch the paint and don't really do much protection. I like the kind that sit flat inside the wheel well. Rockblokz and Tufskinz are two I've come across that I don't mind. I don't care for the look of the Ark. I...

Looks great! Are you planning on running any mud flaps or have you found any you're happy with? The OEM Canadian ones are pretty wide but two things I hate are they are very rigid and could get ripped off and two, they make contact and rub the paint off on the lower fender.

Nice looks great!

What are you running for flaps on this gen?

Hello everyone. I'm running the OEM wide molded mud flaps and where the edges make contact with the body, they are just eating through the paint. I tried some ppf under but it's just rubbing through that too. What other options have you guys found for mud flaps?