Search results

Thanks! I'll go dig in there tomorrow morning.

Can you post a pic of that area? I felt around in there and didn't feel any area big enough for the Midland.

It's pretty straightforward. Hardest part is removing the shift knob. Once it's off, go around the entire panel at the seam with a trim tool and it pops right off going straight up. knob removal (its the same for Tundra and Tacoma):

check out this thread I posted yesterday: https://www.tacoma4g.com/forum/threads/if-youre-looking-for-aftermarket-switches-check-out-switchboss-in-australia.13074/

https://www.switchboss.com.au/collections/toyota/products/uhf-rj45-dash-pass-through-suit-toyota-square

blue LED: https://www.switchboss.com.au/collections/toyota-oem-replacement-square/products/push-switch-suit-toyota-square White LED: https://www.switchboss.com.au/collections/toyota-oem-replacement-square/products/push-switch-suit-toyota-square-white-led-41-styles

EDIT: here's the switch wiring diagram:

I'm not a paid shill for them, but they have more switch variety in both switch graphics and LED colors than Caliraised does. they have white LED switches, which look a lot better in the panel than the blue ones Cali only has. https://www.switchboss.com.au/ Shipping took about 12 days from...

I went with the Aspire ones because of that dumb logo placement. https://www.aspireautoaccessories.com/products/upgraded-wide-view-side-mirrors-for-16-24-tacoma-14-25-4runner-19-25-rav4?variant=40602711851072

Thanks. Doesn't even look straight, it looks crooked

I've watched their videos and don't see a logo. Can you post a pic?

is that a Midland MXT575? Just wondering how it'll fit in the center console.

which door handle covers did you buy? Are you satisfied with them? Does touch unlock work reliably with them?

I used 1/4 acrylic. It is a different material from polycarbonate. You don't want to laser cut polycarbonate, it off gases chlorine gas, aka mustard gas. I didn't tap the holes, if I make one out of metal I will tap those. Tapping acrylic is possible, but it's easy to over torque and shatter...

I did some reading, seems like the disconnect switch is the way to go with the winch. Thanks for your input.

ok, so my winch is rated to pull 360A at max load, and my compressor is rated at 68.6A at max load. My light bar is 15A. So I would need at least a 450a breaker or fuse, correct?

Thanks, what amp fuse would you recommend?

Ever since I decided on a winch, I've been looking for a solution that would give me several points of direct access to the battery, since I already have a compressor mounted in the rear. I knew with the winch bumper I was getting, I'd also need somewhere for a relay for the 20 inch light bar...

I did some more digging around, and found the cable. Bad news is that it's in Australia. It looks identical to the aliexpress one. https://www.allfourx4.com.au/Ironman-4x4-Parking-Sensor-Extension-Kit-suitable-for-Landcruiser-300-Series-IBBPSL090/ https://www.google.com/search?q=IBBPSL090 I...

Thanks, that's about what I was expecting.