- Thread starter
- #1
Picked up a slim under-seat sub and planning to install it under the driver-side seat in my non-JBL 2024 Tacoma TRD Sport.
Most installs/videos I’ve found either mount the sub under the passenger seat or behind the rear seats, but I’d prefer to keep the rear storage area usable.
Current plan:
- BOSS Audio 8-gauge amp wiring kit
- Beat-Sonic BH10 harness
- Using high-level inputs only
- Amp has auto turn-on/signal sensing, so I’m planning to skip RCAs and a remote turn-on wire
Goal is a 100% reversible install with no cutting or splicing of factory wiring.
A few questions:
- Does this setup/plan sound solid?
- Any major reason people prefer the passenger side besides easier wiring access?
- Is there a good/easy ground location under the driver-side seat?
I’ve installed head units and subs before, but it’s been 20+ years, so I’m easing myself back into it. Any suggestions or tips would be appreciated.
Most installs/videos I’ve found either mount the sub under the passenger seat or behind the rear seats, but I’d prefer to keep the rear storage area usable.
Current plan:
- BOSS Audio 8-gauge amp wiring kit
- Beat-Sonic BH10 harness
- Using high-level inputs only
- Amp has auto turn-on/signal sensing, so I’m planning to skip RCAs and a remote turn-on wire
Goal is a 100% reversible install with no cutting or splicing of factory wiring.
A few questions:
- Does this setup/plan sound solid?
- Any major reason people prefer the passenger side besides easier wiring access?
- Is there a good/easy ground location under the driver-side seat?
I’ve installed head units and subs before, but it’s been 20+ years, so I’m easing myself back into it. Any suggestions or tips would be appreciated.
Sponsored
