- Thread starter
- #1
Installed the RCI Rock Sliders today. Happy with the look but had the same problem most people have stated with passenger side forward bolt hole not lining up. Not sure if it’s a RCI jig issue or highly unlikely it’s Toyota frame bolt pattern issue. Anyway made it work by enlarging bolt hole.
A couple other upgrade pictures. Land Cruiser engine and Transfer case skid plates. Had one bolt striped on installation at the factory, probably with impact wrench. Re-tapped bolt hole. Nothing is easy. Black tailgate letters and front grill black Toyota emblem. Painted front recovery points red. Next up fuel tank protection. Haven’t decided on manufacturer. I was leaning toward RCI but might investigate Cali Raised after slider issue.
New member and first post. Great all the information you guys and gals give on this forum. Appreciate you.
A couple other upgrade pictures. Land Cruiser engine and Transfer case skid plates. Had one bolt striped on installation at the factory, probably with impact wrench. Re-tapped bolt hole. Nothing is easy. Black tailgate letters and front grill black Toyota emblem. Painted front recovery points red. Next up fuel tank protection. Haven’t decided on manufacturer. I was leaning toward RCI but might investigate Cali Raised after slider issue.
New member and first post. Great all the information you guys and gals give on this forum. Appreciate you.
Sponsored
Last edited:
