Recent content by demelob

Do you happen to know the screw size/type to attached the bracket to the grille?

What size screw did you use to secure your metal bracket to the plastic grille?

For those that installed the RCI cross member bar, with the Toyota TRD Pro skid plate… Were you able to line everything up where the “hooks” on the front lip of the skid plate, “hooked” onto the cross member? Mine’s floating, and sitting just in front of the cross member. Thanks for the...

Would this even matter, considering the toyota pigtails are 18AWG apparently.

Do you know what the correct size is? My worry is going into the "18 gauge" pigtail. 18 Gauge is pretty thin.

Hi Everyone, I'm the proud new owner of a trailhunter heritage grille, with a 20 inch Heretic light bar. My 2024 TRD sport has the factory AUX switches and factory pigtails. I'm trying to get some clear directive on how to best wire my setup. The heretic light bar draws 11.8 amps, with the...

Hi Everyone, Has anyone taken on the heritage grille swap and used Rigid Industries 20 inch light bar? How was fitment? What mounting bracket did you use?

Hey @Gurvy522. Any luck digging up the file? Much appreciated.

Any update on getting some units to amazon canada? Thanks :)

Would you/your buddy be willing to share the printing file? What type or filament was used? I’m new to the 3D printing world.

If you could dig it up, it would be much appreciated!

Hey @UndergroundTRD. Did your model have the front face camera? Mine doesn't. Looking for a solution to plug up the hole with something that looks good. Obviously you remove the heretic, metal mounting brackets right (found on the sides of the light bar)?

@Gurvy522 Two questions for you, if you don't mind. Are you willing to sell and ship your brackets? I'm in Canada. Also, did your model come with a camera? I'm looking at a way to plug that hole with something cosmetically pleasing, since my model does not come with the front facing camera.