Search results

Do you recall which of the three whites is the solid one?

Do you have any pictures of them installed? Did you also install Icon UCA?

Are you also replacing the UCAs and rear springs?

Femco comes with a crush washer to use.

I have the 45 degree one. Have now install it yet , next oil change. This seems to be the best fit for the RCI skid I have.

Keep us posted to how it works out. We also need pics and before and after measurements.

Those with 24 and 25 show your all Thanks so let’s see the alignment spec from those with 24 and 25 and see what the difference are!

Thanks for the tips and info on this. My parts ,switch and harness have been ordered. Those who have done this have you tried to tap into the bed light switch next to it for the illumination power? If so do you have the pin illumination for that switch to tap into?

Did any of you change your UCA?

Let me know what you find out when you get this done? Thanks for the links on this what running boards are you using?

I Would say they should be the same, I don’t think any changes where made between the two years.

Thanks ,this may help be a start,

Is that the switch that came with the boards? Do you think that the switch could be removed from the base an a hole cut in the blank you took out for the switch? Otherwise it looks pretty good.

Here are the 6 pins. When I try to ring them out I get nothing on any of them.

The switch has 6 pins anyone know which goes to what? I see power switches e from an ECU so bet its a low voltage switch not just 12v in and out!

What bike are you running riding?

Yes I like this one cause the way the hose connects after the cap is screwed off the drain plug. The drain hose pushes a valve inside the drain plug to drain the oil. Have not used the other one but do not like the release handle to open the valve on the other.

So how did you do the factory switch mode. I cannot for the life of me find the correct pins.

Do you recall what pins you used? Just received the switch and not finding what pins to use. Small pins down in there. Thanks if you can help. Edit I think this is electronic switch and needs power to work. Not getting anything with my meter.

How are the front shocks adjusted to fine tune my front ride heights?