2025 Limited black badge cover doesn't fit ?

[Eesh29]

I have a 2025 Limited I ordered the limited black badge cover from the dealership but it doesn't fit. It's too small. The dealership is looking into it, just wondering if anyone else encountered this?

Sponsored

 

[ridetime]

I think they may have ordered the wrong part. I have the matt black ones on my limited and they fit perfectly. Here is what I got.

https://www.amazon.com/Genuine-Toyo...pcontext&ref_=fplfs&psc=1&smid=A1G6GUDBLMQCG0

Toyota part number:

PT948-35243-02

 

[Eesh29]

I think they may have ordered the wrong part. I have the matt black ones on my limited and they fit perfectly. Here is what I got.

https://www.amazon.com/Genuine-Toyo...pcontext&ref_=fplfs&psc=1&smid=A1G6GUDBLMQCG0

Toyota part number:

PT948-35243-02

they ordered the correct part

 

[ridetime]

Apparently not. Your truck is the same as mine and that part fits mine.

 

[Eesh29]

Apparently not. Your truck is the same as mine and that part fits mine.

I was right there. I read the part number on the label in the sealed package.

 

[ridetime]

Hmm, I guess there are either 2 versions of the same part number or you got a “special” truck.

 

[Brupp53150]

Check your window sticker. My blue limited had the "gun metal" overlay already installed at port. I had to remove them to install the flat black overlays. The kit had the front emblem which I can't use as the front emblem on the limited is illuminated.

 

[PRO_Taco]

Could have also been a mispick at the parts depot

 

[Eesh29]

Check your window sticker. My blue limited had the "gun metal" overlay already installed at port. I had to remove them to install the flat black overlays. The kit had the front emblem which I can't use as the front emblem on the limited is illuminated.

This was the issue. Was the gunmetal one hard to remove?

 

[Brupp53150]

Yes, it was a pain, but I did get it off and replaced. The hardest part is getting a starting corner up. I found the lower part of the L the best place to try and wedge the spudger between the chrome piece and the overlay. Once I got it started, it wasn't too difficult. Use 91% IPA to remove the remaining old adhesive. I did the tailgate too. That took some time, but turned out really nice I think..

Sponsored