AUX buttons - anyone have a back button wiring view?

[CrCo35]

I'm wondering if anyone with the 3 factory AUX buttons has a picture of the back side of their factory AUX button wiring they're willing to share so I can see what wires and how many wires connect to each button.

I have spare wires back behind the dummy dash buttons and am trying to figure out if they're for AUX buttons or something else because I have everything else, including fuses/wiring/connectors for pigtails under-hood/bed, but am missing the dash buttons and the Denso relays under the hood - but the relay/fuse spots are wired into the cabin harness.

Sponsored

 

[Pappy]

I'm wondering if anyone with the 3 factory AUX buttons has a picture of the back side of their factory AUX button wiring they're willing to share so I can see what wires and how many wires connect to each button.

Switches are on page 3.

 

[Baltimore]

While Ididn't have the buttons themselves, I did have the button wiring. Take a look at the photos in my post on installing a heritage grille without aux. You'll see pictures of the backside of the dash button panel (if that's what you're looking for)

 

[rijc99]

Switches are on page 3.

You wouldn’t happen to have the diagram for the 4th Aux button would you? I bought the button and connector and am trying to figure out how to wire it.

 

[Pappy]

You wouldn’t happen to have the diagram for the 4th Aux button would you? I bought the button and connector and am trying to figure out how to wire it.

I don't. I looked awhile back in the EWD for that switch on my truck and I didn't see a pre-wired connector for it. I've also had that panel off and don't recall a vacant plug.

 

[StreeTaco]

You wouldn’t happen to have the diagram for the 4th Aux button would you? I bought the button and connector and am trying to figure out how to wire it.

Not 100 on this, but after a few tests, this may work. Your Own Risk.

 

[rijc99]

Thanks Pappy for the 3 switch wiring and StreeTaco for the possible aux 4 wiring. I still need to pick up the pins to set up the connector. Once I get the connector wired I’ll run some tests on the switch.

Sponsored