BAK Revolver X4TS - Solution for sharp edges!

[Designguy96]

I put a Revolver X4TS on truck back in the spring. So far the cover works great, although for the price I think the fit and finish is less than desirable. One area is the end of the rails are rough cut with very sharp edges. When I installed the cover, I knew that I was going to cut my leg or hand wide open one day on it getting in and out of the bed and figured I'd come up with a solution.

Awhile back I made a custom 3D printed end cap to cover the edges and I got some good interest. Since then, I've made some upgrades to the initial design, and I figured I'd post here for anyone interested.

BAK Revolver X4TS Protective End Cap - NEW V2! - Etsy

If you have any questions let me know!

Sponsored

 

[BoboForShort]

Good solution. I was a little disappointed as well. I ended up just filing them down around the edges.