DIY: Heritage Grille + Diode Dynamics 18" light bar on a vehicle without factory AUX

[braaadyyota]

Great write up! Very detailed and worth it for those looking to do the same thing. We need more write ups like this!

Sponsored

 

[Taco Ji]

Read through the entire thread but I don’t see where I can connect the red wire to draw power. I’ve seen many YT videos that suggest the bolt I’ve highlighted in yellow in the passenger fuse box is the power terminal since hybrids have their 12v battery under the back seat. I’m adding a photo of my wiring harness for visual.

 

[Baltimore]

Read through the entire thread but I don’t see where I can connect the red wire to draw power. I’ve seen many YT videos that suggest the bolt I’ve highlighted in yellow in the passenger fuse box is the power terminal since hybrids have their 12v battery under the back seat. I’m adding a photo of my wiring harness for visual.

he picture is they immediate after the following text:


14g-16g insulated female spade crimped, heat shrink for extra protection. It's a perfect and very snug fit onto the unused 30-50A spades. They are all 12v constant hot sources. Then folded the tail with inline fuse into one open bay space, while tucking the flex down into the box and using a zip tie through the hang tab slit to secure the relay from being able to bounce/move/rub around inside the F&R box. If I need to service, I just clip the zip tie to lift it higher and out.

 

[Taco Ji]

Are you talking about the driver side fuse box or passenger. Check this video Start at 1:22.

 

[Baltimore]

Are you talking about the driver side fuse box or passenger. Check this video Start at 1:22.

My original post explains all of this in extensive detail. Please go neck and reread it fully. If you are uncertain, please have someone experienced do the wiring. Don't gamble with your life or your truck. You are not replaceable and your truck was an expensive investment.

 

[Taco Ji]

My original post explains all of this in extensive detail. Please go neck and reread it fully. If you are uncertain, please have someone experienced do the wiring. Don't gamble with your life or your truck. You are not replaceable and your truck was an expensive investment.

Your original post does not explain what I need. Thanks for wasting my time.

Sponsored