How much rake does your stock suspension Tacoma have?

[Powhunter]

I’m trying to determine if different models might be higher in the front. Post what model you have and what your rake is (difference in height between front fender to ground and rear fender to ground)
I have a TRD OR on stock suspension and my rake is 2.0 inches.

Sponsored

 

[Richm]

I’m trying to determine if different models might be higher in the front. Post what model you have and what your rake is (difference in height between front fender to ground and rear fender to ground)
I have a TRD OR on stock suspension and my rake is 2.0 inches.

2024 TRD OffRoad, stock suspension

Going by wheel well opening, i have 37" in the rear and 35 1/2" in front
If you measure the lip on the bottom of the rocker panel, i have 16 1/2" rear measurement and 15 15/16" in the front.
So if i did a 1 1/2" front lift, it would even out the wheel well openings but in my opinion it makes it look nose high if you go by body lines and bottom of rockers/cab

 

[PNWkip]

2024 TRD OffRoad, stock suspension

Going by wheel well opening, i have 37" in the rear and 35 1/2" in front
If you measure the lip on the bottom of the rocker panel, i have 16 1/2" rear measurement and 15 15/16" in the front.
So if i did a 1 1/2" front lift, it would even out the wheel well openings but in my opinion it makes it look nose high if you go by body lines and bottom of rockers/cab

Just discovered this first hand with the bilstein 5100s. Went with 1.4" which measured perfectly level at the wheel wells, but to my eye it looked a bit nose high. Put a .5" spacer in the rear and going by rocker/cab measurements that made the truck perfectly level.
I had originally thought I had 2" of rake because I was measuring by the wheel well.
Ultimately for me I'm going down to 1" in the front and keeping a .5" spacer in the rear to keep a little bit of rake.

 

[gmalkmus]

With stock suspension, there really isn’t too bad of a rake. Saving for a kit kit so I don’t end up squatting the truck every time I put something in the bed with a leveling kit. Been there done that in my last truck.

Sponsored