Rear recovery hooks and frame reinforcement

[TimC.]

Not sure yet but it will be less than the ARB recovery hooks. Not looking to gain much profit but rather help anyone who has the models without a reinforced frame. I'm actually a bit aggravated that 50K won't give you this already. Nevertheless, I will post everything in a week or so. Thanks for your interest.

Sponsored

 

[Canufixit]

I might be to make this up on my lathe ... is there a print of the parts available so I can peruse it ??? Thanks
SteveC

 

[TimC.]

I have measured as I went. Multiple trial pieces made and adjusted. I have the final made. I do not have a drawing but I will make one and post. I will advise that the inside frame tube can slightly vary due to hole punching process and mass production. These are a pain to make until you make them.

 

[Daneger]

Should still be a tolerance on the overall length of the sleeves though. Still, great job. I def pinched the frame rails on my SR5 torquing the bolts to 125ft/lbs. If'n you do make me a set I'll have to trim them to fit.

 

[eskudo12791]

Hey Tim nice job on the collars. I’ve been searching for someone who makes them over here in SoCal with no luck. Once you’re done and if you ever feel like making another set, I’d be happy to pay for them. Thanks!

something like this?
https://square.link/u/lBoIMTLX?src=embed

 

[oldschool_94]

something like this?
https://square.link/u/lBoIMTLX?src=embed

Yes like that! How did you come across that website?

 

[eskudo12791]

Yes like that! How did you come across that website?

saw them posted on here recently as an alternative to ARB

 

[TimC.]

If you have a look at your frame you have 2 different size holes. This is not a factory weld-in. For me, I wanted what the factory designed and fabricated. This is a shade tree mechanics version.

 

[brstowell]

I would love a set too! Gladly pay you for them.

 

[Daneger]

Cornfed ones kinda look just like the factory ones... Just saying.

 

[brstowell]

I got ChatGPT to create a drawing, based on my measurements, would love to compare the measurements. Let me know how it lines up with yours and I will create a drawing for everyone to use.

 

[Daneger]

I haven't received my Corned sleeves yet, and I'm about to leave for a camping trip, but when I get back I'll measure them. Probably won't get to weld then in until next weekend, then I'll take pics.

Sponsored