Rear recovery hooks and frame reinforcement

[TimC.]

Not sure yet but it will be less than the ARB recovery hooks. Not looking to gain much profit but rather help anyone who has the models without a reinforced frame. I'm actually a bit aggravated that 50K won't give you this already. Nevertheless, I will post everything in a week or so. Thanks for your interest.

Sponsored

 

[Canufixit]

I might be to make this up on my lathe ... is there a print of the parts available so I can peruse it ??? Thanks
SteveC

 

[TimC.]

I have measured as I went. Multiple trial pieces made and adjusted. I have the final made. I do not have a drawing but I will make one and post. I will advise that the inside frame tube can slightly vary due to hole punching process and mass production. These are a pain to make until you make them.

 

[Daneger]

Should still be a tolerance on the overall length of the sleeves though. Still, great job. I def pinched the frame rails on my SR5 torquing the bolts to 125ft/lbs. If'n you do make me a set I'll have to trim them to fit.

Sponsored