Search results

I saw a YouTube video that had a cover with the ARB bed bar mounted on it. I think they had to modify it. but looked decent

Yes you are correct. I guess you used the other wire from the pigtail that would go to AUX 3? Just means you hypothetically still have AUX 1,2 and 4 available

New switch looks good.

the pkg on the top row all the way to the right. yellow outline on paperwork.

The pigtail that I used for the rear is using AUX 4. The pigtail is in the bag with two pigtails in the same bag. The paperwork that is included with the pigtails shows the amp draw from each colored wire and I wired the ground to ground and the 10 amp to the red wire (main light) iirc. the...

Sounds like the shop that worked on your taco didn't take their time ro remove clips and such?

Might have to get some just in case.

Great, I was reading someone's install that said that they had to scratch that because they weren't able to have access due to something in the way. Now I see that it will be ok. I have a better idea of where to mount the bulkhead. Thanks (side view looking towards the rear) (Bottom view...

Was there anything blocking the air chuck line between the truck bed side and the outer bed skin? The line going to the data box. Thanks

The hole is made for access to air compressor. Easier for install and easier to service. Most of all to display. Hole is not necessary at all The video from OP should answer any questions.

Looks good. Depending on where you are placing the chuck, the line might be too long.

How does the final install look now?

The website says that they will only sell the kit. Not sure how much wiggle room there is.

I did use a creeper which made it easy. I was able to slide from light to light even under the spare tire with no issues.

Ran the wires above the spare between spare and bumper. Just follow the factory wiring. Once everything is tested then just zip tie to factory wiring.

Of the three plugs, one goes to the pigtail which eliminate the connector that is on the harness with the ground wire attached (bottom right packed wire). As far as installing the lights, just use a long extension and you will be fine aside from the small skpeaker (pictured). .

I'm glad that I got my order in when I did. I did not have to lower the spare tire however I did remove the small speaker located in front of the passenger side bumper light cover. Here is the pic of the speaker in question. I only needed the factory wire in kit for the rear switch and the...

Yep your video is linked in to their site for the bed mounted ARB compressor. Another question, Did you get the pump up kit as part of the deal. I don't see it as included with the kit. Thanks

You can install the TH compressor if you have the data cubby bed side drivers side (USB connection box) however more than likely that would have to stay with the vehicle permanently as appose to a bolt on that can later be unbolted and removed. I didn't like that option. I am leaning towards...

I watched your video several times today. The C A Tuned has on their website "video coming soon" I hope you get something if they use it. Great video. I am stuck between going the CA Tuned route and doing something on the drivers side. Similar to the Trailhunter location but with an ARB Twin.