Bedside MOLLEs compatible with factory air compressor

[Victory 4x4]

Gotta shoutout to @Dave. With his help, we made an update to our Bedside MOLLEs to make them compatible with the factory compressor mounted in the bed. Took us a minute to run through the inventory, but now all panels moving forward are compatible.

https://www.victory4x4.com/product/VT4RMP.html

Sponsored

 

[tgrneal]

approximately how much trimming would I need to fit these with Deckd drawers?

 

[ejosesa]

Do you have a different font for the “there and back?”
Seems to clash with the ruggedness of the panel and brand logo.

 

[mattlee]

Very nice.

 

[Victory 4x4]

Do you have a different font for the “there and back?”
Seems to clash with the ruggedness of the panel and brand logo.

No, but you can always just leave the panel off, or 3D print something fun.

 

[Victory 4x4]

approximately how much trimming would I need to fit these with Deckd drawers?

A whole bunch, may not be worth it.

 

[tnjwinters]

Any word on a 6’ bed version?

 

[mtbocoee]

Not to say anything against Victory 4X4 or their products, but I installed Toyota's version for my 6' bed Trailhunter about a month ago. I needed them to install before I had an Alu-cab Contour Canopy set because most install under the bed rails. At the time they were the only side Molle panels I could find for a 6' bed Trailhunter. They end before the compressor and accessory panel and have an odd grid and hole pattern, but they will suffice for now.

I checked every aftermarket company including Victory and this appeared to be it.

 

[tnjwinters]

Factory is all I’m finding as well but I don’t like how short they are. Seems like a poor use of space.

 

[mtbocoee]

With a Trailhunter you can't hang anything over the compressor or the passenger side outlet so you really don't lose anything. If you don't have either, full length makes more sense.

Sponsored