Light Bar Install

[bsquaredMTB]

So, I did a thing. Finally got the light bar I've been wanting to complete (for now) my setup. I ordered this light bar from Amazon. I thought about going w/the CaliRaised version but it was a bit too long for my roof rack. Install was mostly straightforward. I am going to be using the dual OEM Square switch from CaliRaised LED but for now I'm using the switch that came w/the light bar. The toughest part of the install was getting through the firewall. I ended up going around the rubber grommet as suggested in a video i saw online. Once I did that, the rest of the install was a breeze. I spliced the wires coming from the light bar with a 16 gauge 3 wire setup so I could run the wire from the light bar, behind the light bar and down the pillar of the driver side. Other than that, the rest was pretty much plug and play once I understood how to wire everything up.

Sponsored

 

[YukonTRD]

Why would you not run it through one of the Aux switches? Or are all 3 already in use?

 

[bsquaredMTB]

My brother asked me the same thing! lol. So, CaliRaised LED has a cool dual switch that shows both white and amber lights. I thought about using 2 switches to go straight to the aux switches, but I liked the way this looked better. Probably a bit "diva" on my part

 

[ixo]

 

[bsquaredMTB]

I'll send an updated pic once I install the real switch lol. I was just too excited to install it before it arrived

Sponsored