Single ARB Compressor Engine Bay Installation Using Custom Bracket (3D Print File Inside)

diabeetusman said:

New to ARB stuff, but is this the compressor you used?

Click to expand...

diabeetusman said:

New to ARB stuff, but is this the compressor you used?

Click to expand...

Sagebrush said:

I designed a bracket and 3D printed it using PETG. The filament has a heat tolerance of 168º, and after testing the bracket bolted to the bay without the compressor, it got to 127º. The bracket is stout.

If you are interested, the file and printing instructions are on Thingiverse:
https://www.thingiverse.com/thing:6721234

Click to expand...

Sagebrush said:

I designed a bracket and 3D printed it using PETG. The filament has a heat tolerance of 168º, and after testing the bracket bolted to the bay without the compressor, it got to 127º. The bracket is stout.

If you are interested, the file and printing instructions are on Thingiverse:
https://www.thingiverse.com/thing:6721234

Click to expand...

IAmGroot said:

Would you happen to have those numbers?

Click to expand...

Sagebrush said:

Is that good enough?

Click to expand...

IAmGroot said:

Not sure why the guy wanted to confirm dimensions

Click to expand...

Sagebrush said:

He may have been concerned it was bigger than his machine could handle.

Click to expand...

Sagebrush said:

He may have been concerned it was bigger than his machine could handle.

Click to expand...

n118nw said:

PETG.. do you think that can handle the high temps in the engine bay?

Click to expand...

Romer said:

I have a line on getting it printed.

Click to expand...