Tacoma Limited : Blackout Progress

[Baltimore]

If I end up following through with my Limited order, I would likely be doing the chrome delete as well. I haven't decided if I am going to go with the Pro or Trail Hunter grille, but did the forward facing camera mount up just fine, or did you need to get a new bracket to mount it to the Pro grille?

Pro grille is silver letters on gloss black face
Trailhunter grille is bronze letters on matte black face

The bracket from the limited grille is not compatible. Rave and others make a bracket that attempts to keep you out of GTS+ territory but you'll have to do the service menu calibration/process as their bracket angle isn't correct. If you switch to the correct bracket, it's a full camera assembly. You'll also need to access GTS+ to change the grille setting (image will be flipped), or pay a dealer to make the settings change. Then do the calibration.

Sponsored

 

[JayTech]

Pro grille is silver letters on gloss black face
Trailhunter grille is bronze letters on matte black face

The bracket from the limited grille is not compatible. Rave and others make a bracket that attempts to keep you out of GTS+ territory but you'll have to do the service menu calibration/process as their bracket angle isn't correct. If you switch to the correct bracket, it's a full camera assembly. You'll also need to access GTS+ to change the grille setting (image will be flipped), or pay a dealer to make the settings change. Then do the calibration.

Yea I work for a Toyota dealer so getting it calibrated isn't an issue, I just wasn't sure about the camera fitment. Would likely just get the bracket from Rave or something then because its far cheaper than buying a new camera.

 

[Eesh29]

No. Well.. you could. You need upper bumper variant #5 (53931-AK050) if you want black with fog with sensor.
You will also need two sensor mounts that stick to the backside. The black ringed ones are part number 89348-04010-C.

The sensor clips are 3M tape, not reusable.

I made the error the first time of ordering variant #1 based on posts and (incorrect) eBay listings. Had to eat the cost to rebuy the correct one.

Do you know what the part number is for the two front bumper 2 Black Sensors that I need to replace the silver ones?

 

[Baltimore]

Do you know what the part number is for the 2 Black Sensors?

The actual sensor unit? no. I plan to reuse the ones I have so didn't bother looking up.
The ring is listed in the post.

Changing the sensor unit itself, or even swapping locations) requires a mandatory GTS+ calibration process.

Sponsored