- Thread starter
- #1
Has anyone come up with a hydrophobic air filter cover for their Trailhunter?
Sponsored
Yea if there’s an imminent storm on the way - rain sleet or snow - having a waterproof sock over the intake isn’t a bad idea until you forget about it one day and remote start.Maybe something like
![]()
So I purchased and installed today a “Filterwears” K338 pre-filter. Used a 6” clamp to secure and went for a drive. No issues so far. Will check in a week or two to make sure it stays in place. I hope that if water does get into the intake this winter that this stops any water entry into the engine. I did verify there are two small drain holes in the filter box. Bonus is that as this truck has a washable air filter and now a pre-filter, this should help to keep it clean as well.
![]()
So to be clear, these are K&N oil type filters? If so, I am not a fan of those in general because it is easy to under or over oil them. On my 2005 I run a set of AFE dryfit filters that I rotate out every oil change, rinse and then dry, no oil.Appreciate the link to this post and tip to strap on a clamp. The Filterwears part number I have is different-hope it is because it is updated for 4G. I got this in April ‘26. Will wash filter and give this a try.
Ordered yellow to help me see the red oil when inspecting.
![]()
I just confirmed that and ordered a spare filter, pricey sucker. Back to oiling, ugh...Yes the Trailhunter and TRD Pro come with an oil on gauze (K&N style) filter from the factory.