I love that design too, kinda sad I didn't come across it when window shopping. They definitely look just as good!Those "fang lights" looks wicked cool. I almost bought a set but then I came across another design. Now I'm conflicted on which one to get. ?
I just had these installed. Do you by chance know how to have just the amber lights display and not the white?Just installed these and came to figure out if anyone knows what wires to TTap into.
I have a signal wire, which I already tapped into, but now I'm left with a wire for low beams and a wire for DRL.
Playing around with the headlight wiring I was only able to find one singular wire that provided power to the aftermarket lights but that were stays hot as long as the vehicle is in ACC or started. So for now I just tapped into that using the DRL wire on the aftermarket lights so I still get the cool sweeping startup, but I would like to wire it correctly
You'd probably have to mess with the control box, I thought about it myself today funny enough.
Bought the L2R brand from Amazon. Haven’t installed yet. Seems like you may have the same wires that I have. If and when someone on here figures it out, I hope they would share.I went ahead and removed the bumper - again - to install the fang lights. This is the physical install. I left the wiring to be done later, once we figure out the correct place to tap into the stock wiring harness. Note that I zip-tied the plugs to existing wiring so its easy to access once it's all back together.
A couple of observations: I don't think you can do this install without removing the bumper. The stock inserts have very stiff tabs, and the mounting points are fragile. I would advise against trying to pry this out from the outside. Bumper removal isn't that hard, took about 10 minutes the second time. FYI.
Take the plug off, turn on your emergency flashers and measure the voltage with a multimeter. That's what I did, I don't have the LED turn signals so not sure if the wires would be the same
can't help with the wiring as my truck hasn't been built but those are the fangs I want, please post a video when they are done!Yes, if someone could post the signal wiring, that would be great. I have them installed and used a fuse tap in the box near the wiper fluid that only runs on accessory. I haven't hooked up the signal wires yet because I haven't had time to explore which wire controls the signal.
Can you take a pic of where you tapped into for the fuse tap into the accessory slot? Also if you used add a fuse what amperage fuse did you use? Pics please. Also the signal wire taps into your blinker peach colored wire. Photo showed is from a fb member. This is the route I was going to use if not successful with the add a fuse.Yes, if someone could post the signal wiring, that would be great. I have them installed and used a fuse tap in the box near the wiper fluid that only runs on accessory. I haven't hooked up the signal wires yet because I haven't had time to explore which wire controls the signal.
