Just installed the rear dome light for 2024+ Tacoma

[GSPHerder]

I did the Meso, easey peasey, no issues.

Sponsored

 

[tacomasport1121]

Meso and Lexland are very similar. I think Lexland just had a bad batch of wire harnesses sent out. If you don’t want to fix yours, contact Lexland. If not, it’s an easy fix. Just push the black and blue wire pins out and swap locations. I pushed the pins out with needle nose pliers and gently pulled at the same time. Easy quick fix

 

[Lexland_Official]

Bought and installed one of these weeks ago. Took longer than it should’ve though because it was mis-wired from the factory. Luckily I didn’t have to solder anything

Do you still have any issue?

 

[Lexland_Official]

Would you by chance happen to be able to snap a picture of the wire configuration that worked for your light?

Here's the instruction manual,please check:https://cdn.shopify.com/s/files/1/0...ED_Light_Installation_Manual.pdf?v=1776308533

 

[Lexland_Official]

FYI it seems your latest batch isn’t wired properly which is causing issues when installed.

If you have any issue,please feel free to contact our customer service team,they will help you within 24 hours.

 

[FinallyErik]

Do you still have any issue?

No. I was able to fix it myself.

 

[Stingertron]

Meso and Lexland are very similar. I think Lexland just had a bad batch of wire harnesses sent out. If you don’t want to fix yours, contact Lexland. If not, it’s an easy fix. Just push the black and blue wire pins out and swap locations. I pushed the pins out with needle nose pliers and gently pulled at the same time. Easy quick fix

Silly question but which end did you swap? The big or the little one?

 

[tacomasport1121]

Silly question but which end did you swap? The big or the little one?

Big end that plugs back into the Toyota harness in the header. I able to pull the pins and swap on my work bench.

 

[tacomasport1121]

I heard they were coming out with a version 2.0 that should fix it . I’ll keep you posted with what I find out.

 

[maxx075]

I heard they were coming out with a version 2.0 that should fix it . I’ll keep you posted with what I find out.

Should be full disclosure that you're sponsored by, biased, and thus promoting Lexland.

 

[28Gauge]

I tried installing this today, but the unit didn't work as expected. It would stay indefinitely with the doors locked. If you turned it off, it of course wouldn't turn on when the door was opened. Beats me what is wrong, so I gave up and reinstalled the OEM dome light. I should note that I bought some door puddle lights at the same time and they work just fine.

Sponsored