T24A-FTS Throttle Body and Throttle Body Elbow Measurements

[JustDSM]

Thought I'd pass on a few measurements taken from a spare Throttle Body and Throttle Body Elbow off of the Tacoma (it's the same for other T24A-FTS platforms like the LC250/4Runner).

Located what I think might prove to be a choke point.. Enjoy!

*My calipers aren't perfectly positioned here, but the ID of the TB is 60mm, which gives us a cross-sectional area of ~2827.4 square mm excluding the throttle plate/bar.

*Choke point located!

With an OD of ~47.75mm and a wall thickness of ~3.25mm, that is an approximate ID (at the radius) of about 41.25mm (~1336.5 square mm).

Sponsored

 

[Devildog81]

There’s only one cold air intake kit that replaces all that, and that’s one K&N makes correct? Someone needs to come up with just a replacement elbow for this.

 

[Rsuperman]

How would we correct this without throwing codes?

 

[Lennyz1]

There’s only one cold air intake kit that replaces all that, and that’s one K&N makes correct? Someone needs to come up with just a replacement elbow for this.

That elbow and TB are all post turbo. CAI kits only do pre-turbo that I am aware of.

 

[JustDSM]

How would we correct this without throwing codes?

Should a replacement for the TB Eblow be/become available, it would not be a part that would trigger a CEL.

 

[Rsuperman]

Thank you fine sir.

 

[Devildog81]

Should a replacement for the TB Eblow be/become available, it would not be a part that would trigger a CEL.

One more thing to add to your R&D list???

 

[Bravada]

Stage 2 of your tune, has me saving up. I can't wait. Sounds like I'll be busy replacing several deficiencies to mo power.

Sponsored