What did you do TO / WITH your 4th gen Tacoma today?! 👨‍🏭 🧰 📸

[RokeHi]

Installed a RCI off road front cross member and attached a TRD Pro Skid Plate.

Sponsored

 

[maxx075]

Got tired of the seat belts scarring the plastic. So I wrapped the panels with a carbon fiber wrap.

 

[TFOUTS]

Got tired of the seat belts scarring the plastic. So I wrapped the panels with a carbon fiber wrap.

That's what I need, where did you get it?

 

[maxx075]

That's what I need, where did you get it?

VViViD XPO Black Carbon Fiber 5ft... https://www.amazon.com/dp/B00L9J4JRG?ref=ppx_pop_mob_ap_share

 

[CyberTaco]

Got tired of the seat belts scarring the plastic. So I wrapped the panels with a carbon fiber wrap.

Looks great!

 

[rijc99]

Test fitted my hitch skid. Will use skid when off-roading and flag as daily.

 

[SnowmanJPS]

Picked up some 6x6x8’s for a new fence project coming up

 

[nurp42]

Picked up some 6x6x8’s for a new fence project coming up

Looks like you're getting even more use out of the versa-trax than I am

 

[Dansflhti]

Picked up some 6x6x8’s for a new fence project coming up

I could nearly afford to buy a Pro..but not the 6x6 posts too.

 

[SnowmanJPS]

Looks like you're getting even more use out of the versa-trax than I am

This was a great purchase hands down!

 

[CyberTaco]

I installed the OPT7 Triple row LED tail light bar using the very strong bar magnets on my Taco. One thing to note is that the magnets are very strong and wiil draw blood if you get your finger pinched between 2 of them! Another thing is that you must feed the light bar from behind the bumper because the connectors won't fit between the bumper and the bed. No instructions came with the lightbar, so watch a YouTube video.

 

[SnowmanJPS]

Made it to the highlands in Cape Breton, love this little truck, also finally seen a full hybrid battery for the first time regenerating braking

 

[HoptownBob]

I installed the OPT7 Triple row LED tail light bar using the very strong bar magnets on my Taco. One thing to note is that the magnets are very strong and wiil draw blood if you get your finger pinched between 2 of them! Another thing is that you must feed the light bar from behind the bumper because the connectors won't fit between the bumper and the bed. No instructions came with the lightbar, so watch a YouTube video.

My connector fit just fine. Put the light strip in place from above the bumper then feed the connector though.
Climbed under and connected the wiring harness from below.

 

[CyberTaco]

My connector fit just fine.
Climbed under and connected the wiring harness from below.

That's how I had to do it. Somehow I missed that little piece of advice.?

 

[bigbunk62]

Drove home across 4 states, 6 hour drive on 85% backroads, 50-55 mph, started with full tank.

Sponsored