HOW TO: Rigid SR-L Series Lights for ARB Rear Bumper Installation

[myhikingboots]

Cool, but I just thought that meant, it wasn’t a powered circuit until you connected the jumper harness in the engine bay, but I have no idea, lol. Also confusing is the fuse labels, jeez!

Sponsored

 

[Ray T]

Agreed I’m no electronic guru by any means but with some help from SPV and figuring out that I had to get power to the switch from the engine compartment all was hooked up and working properly but it is #4 aux

 

[SPV Parts]

Yeah it is confusing because I don't have a truck in front of me.

So is this one a power SOURCE? Or is it an INPUT for pass throughs somewhere else in the truck?

Because from my understanding THIS one was the POWER OUT from the Aux switches. Which is the Green wire (Aux 2) Black wire (Aux 1) and White wire (Aux 3) with the black/white striped wire the ground?

 

[NukenJED]

I believe the blue sheet connector plugs into the upper plug and supplies loads up front. These are already hot and have power. I think the green sheet connector plugs into the plug inside the cab, and should also be hot. You have to install the jumper harness in the engine bay to power the rear plug. That’s how my 25 Pro with 4 AUX switches should be anyways.

 

[Ray T]

Yes you have to use the pigtail which connects by the washer fluid it is tight tough to get too to connect back wires to the switches

 

[NukenJED]

It took me forever to find the plugs, remove the caps, and install the pigtail jumper. Ugggh.

 

[Ray T]

I thought it was a pain in the 🫏 hard as hell to get your hands down in there!

Sponsored